Dremel 3D45 Operating And Safety Instructions Manual page 25

DM 160992A425AA 07-17_3D45 7/7/17 11:21 AM Page 25
9. Filament will be drawn into the extruder
and begin to exit from the hot extruder tip.
NOTE: Your Dremel 3D45 was tested by
building objects before leaving the factory.
These test objects may have been made
with a different filament color than you are
using. Therefore, a small amount of
filament may be remaining in the extruder.
10. When new filament appears from
extruder tip, tap "done" on touch screen
to complete filament load process,
return to main menu, and calibrate
extruder. Carefully remove excess
filament without touching hot extruder
tip. If necessary, carefully remove debris
from extruder tip with needle nose
pliers.
FILAMENT TYPE AND SETTINGS
Filament Type
Nozzle Temperature Range
Optimal Nozzle Temperature
Build Platform Temperature Range
Optimal Build Platform Temperature
Print Speed Multiplier
Recommended Speed Multiplier
Object cooling fan setting
Getting Ready to Build
CAUTION
!
when clearing debris. Dremel 3D45 will not
work properly with a damaged extruder tip
and will require replacement.
11. Close 3D45 lid and door.
PLA
190 -230 C
220 C
0 – 60 C
35 C
10 – 300%
100%
Fan Range 0 – 100%
100%
DV-160992A425, Page: MUL (VAA), downloaded at: 2017.12.19_18:02:14, by PT-RT/MKP2_Karan.Patel
25
Use extra care not to
damage the extruder tip
ECO-ABS Nylon
190 -230 C 220 – 280 C
220 C 255 C
0 – 70 C 0 – 100 C
45 C 80 C
10 – 300% 10 – 300%
100% 90%
0 – 100% 0 – 100%
100% 50%