Dremel 3D45 Operating And Safety Instructions Manual page 26

DM 160992A425AA 07-17_3D45 7/7/17 11:21 AM Page 26
26
FIG. 3
Tab
Front Clip
PREPARING BUILD PLATFORM
Do not touch the extruder
!
tip or
platform during Dremel 3D45 operation or
until it has cooled down to at least 60°C
(140°F). Contact with the extruder tip or
build platform during or after operation before
tip and build platform has cooled may result
in personal injury.
Do not drop the build
WARNING
!
platform. Tempered glass
plate may break and result in personal injury.
Do not remove tempered
WARNING
!
glass plate from plastic
holder. Contacting with tempered glass plate
edge may result in personal injury.
Before every build make
CAUTION
!
sure that the build platform is
covered with glue from the supplied glue
stick. If glue is not used, it may cause poor
object build quality.
1. Remove build platform by first pressing
down and releasing the two clips located
at the front of the build platform, then lift
the build platform off the base using the
build platform tabs (figure 3).
Getting Ready to Build
Rear Clip Rear Clip
Base Build
Platform
2. For best results, apply a thin layer of glue
with the provided glue stick to the build
platform, figure 4.
heated build
FIG. 4
NOTE: To clean the build platform, rinse
the platform with warm water and dry with
a towel.
3. Install the build platform by first inserting
the rear of the platform onto the rear clips,
then press down on the front of the
platform until it snaps in place.
DV-160992A425, Page: MUL (VAA), downloaded at: 2017.12.19_18:02:15, by PT-RT/MKP2_Karan.Patel
Tab
Front Clip
Glue
Stick