Table of Contents
Advertisement
Find Quality Products Online at:
Getting Ready to Build
Observe
all
WARNING
!
warnings
and
instructions when using the Dremel 3D40.
Failure to do so may result in fire, equipment
damage, property damage or personal injury.
Do not touch the extruder
WARNING
!
tip during operation or
until it has cooled down to at least 60°C
(140°F). Contact with the extruder tip during
or after operation before tip has cooled may
result in personal injury.
Use only DREMEL filament.
WARNING
!
Use
of
filament
authorized by Dremel may result in
equipment and property damage.
Do not pull the filament
CAUTION
!
out. Doing so may damage
the extruder.
LOADING/CHANGING FILAMENT
1. Start filament load/change process by
tapping "Filament" button on touchscreen.
Extruder will move to front right corner of
print area and extruder tip will begin to
heat.
FIG. 1
Open
Close
GlobalTestSupply
www.
provided
safety
2. After extruder stops moving, open the
3D40 Lid for better access to extruder.
3. If existing filament is loaded, cut existing
filament near extruder intake and tap
"Next" button on touchscreen.
not
4. Remove Spool door by rotating it counter
clockwise and remove existing spool if
one is present, see figure 1.
Spool
Holder
Filament
Filament
Guide Tube
24
.com
sales@GlobalTestSupply.com
Advertisement
Table of Contents
