Dremel 3D45 Operating And Safety Instructions Manual page 35

DM 160992A425AA 07-17_3D45 7/7/17 11:21 AM Page 35
PROBLEM
3D45 will not connect to my
network.
3D45 will not retrieve a token.
Cloud slicer will not connect to
3D45 or shows "printer offline".
Token invalid.
Build did not start when sent
over network.
Troubleshooting
CAUSE
Printer too far from wireless Reposition 3D45 to be closer to your
router. router.
Network password or SSID Re-enter your password/SSID or
incorrect verify your password with your
network owner.
Network password incorrect. Re-enter your password or verify
your password with your network
owner.
Network has a firewall. Enter network proxy information.
3D45 not connected to network. Check 3D45 network settings and
retry connection.
Verify the current 3D45 token Use "Get new token" to generate a
using "Tools/About" and retry. new token and retry connection.
Note this will remove any users that
are sharing your printer.
Filament ran out. Load additional filament and resume
build.
Doors open. Doors must be closed to start builds
over your network, start build from
print queue.
Model was already building The build platform must be clear to
start a build over your network, clear
the build platform and start build
from print queue.
DV-160992A425, Page: MUL (VAA), downloaded at: 2017.12.19_18:02:19, by PT-RT/MKP2_Karan.Patel
35
CORRECTIVE ACTION