Grandstream Networks GRP2612 Administration Manual page 50

Feature
Predictive Dialing
Source
Onhook Dial Barging
Off-hook Auto Dial
Off-hook Auto Delay
Off-hook Timeout
Enable Live DialPad
Live DialPad Expire
Time
Enable Automatic
Redial
Automatic Redial
Times
Automatic Redial
Interval
Bypass Dial Plan
Through Call History
and Directories
Disable Call Waiting
Disable Call Waiting
Tone
Ring For Call Waiting
Disable Busy Tone on
Remote Disconnect
Disable Direct IP Call
Use Quick IP Call
mode
not see any predictive numbers while dialing a number.
Predictive dialing feature will sequentially search the number based on the
selected sources from these: Call History, Local Phonebook, Remote
Phonebook, Feature Code.
When disabled, on-hook dialing won't be interrupted by an incoming call.
Default setting is Disabled.
Configures a User ID/extension to dial automatically when the phone is off
hook. The phone will use the first account to dial out. Default setting is "No".
Configures the number of seconds during which the phone will wait before
dialing out when off-hood auto dial number is configured. The default is 0.
If configured, when the phone is off hook, it will go on hook after the timeout
(in seconds). The default value is 30 seconds. Valid range is from 10 to 60.
If enabled, When the phone is Offhook it will automatically dial out the
number punched in after the number of seconds that the user had set.
Set the Live DialPad expire time before initiating the call using Live DialPad
feature. Interval is between 2s and 15s. Default value is 5s.
If enabled, the phone will redial the number a configured number of times
with a configured interval (in seconds) in between each redial.
The number of times to attempt to call using Automatic Redial feature.
The interval between each call attempt using Automatic Redial feature.
Enable/Disable the dial plan check while dialing through the call history and
any phonebook directories. The default setting is "No".
Disables the call waiting feature. The default setting is "No".
Disables the call waiting tone when call waiting is on. Default setting is "No".
Disables / enables the call waiting tone when the call waiting feature is
enable. Default is disabled.
Disables the busy tone heard in the handset when call is disconnected
remotely. The default setting is "No".
Disables Direct IP Call. The default setting is "No".
When set to "Yes", users can dial an IP address under the same LAN/VPN
segment by entering the last octet in the IP address.
To dial quick IP call, off hook the phone and dial #XXX (X is 0-9 and XXX
<=255), phone will make direct IP call to aaa.bbb.ccc.XXX where
aaa.bbb.ccc comes from the local IP address REGARDLESS of subnet
mask. #XX or #X are also valid so leading 0 is not required (but OK). No SIP
GRP26XX Administration Guide
P a g e |
50