Operation
Connecting the
the Blast
Blast Hose
Connecting
Connecting
the
Blast
Hose
Hose
Hose
1. Make sure the inlet hose connections are tight,
and that hose restraints are properly installed
and secure.
2. Open the air supply valve (125 psi, 8.6 Bar, 0.86
MPa maximum). If necessary, use a regulator in
the supply air line to meet these specifications.
NOTE: See air compressor manual for operation
NOTE:
NOTE:
and startup information.
10
Hose and
and Air
Air
Hose
and
Air
N
R U
F
O F
T
A R
S T
3. Connect the blast hose, hose restraints, control
hoses, and coupler pins.
NOTE:
NOTE: If you are using an electric blast control
NOTE:
switch, check all of the electrical connections
from the panel to the blast control.
Make sure no electrical connections will
be exposed to water. Exposure to water
could cause a short circuit and damage the
equipment.
NOTICE
NOTICE
NOTICE
334666C