Using The Wash Feature - Graco EcoQuip EQ200T Operation, Repair, And Parts

Using the the Wash Wash Feature
Using Using the Wash
The wash feature causes air-driven water (without
abrasive) to rinse areas that have already been
blasted with abrasive. It is also a convenient feature
for flushing abrasive from the blast hose.
NOTICE NOTICE NOTICE
There will always be some residual abrasive in
the blast hose. Never use the wash feature on
any surface other than where you have blasted, or
intend to blast. It will affect/dull the surface.
NOTICE NOTICE NOTICE
Do not use the wash feature on wood that has
been blasted. It could damage the wood and cause
the grain to rise. Wait for the wood to dry and then
use a broom, brush, or vacuum to remove any
residual abrasive.
1. Close the abrasive ball valve.
334666C
Feature
Feature
2. Turn the selector valve to WASH.
3. Blast 1 – 2 minutes until the abrasive is cleared
from the hose.
4. The equipment is now ready to wash any
previously blasted surfaces.
Operation
17