Connecting Output Hose To The Pumps - Graco UniDrum C59784 Instructions And Parts List

Installation
Connecting Output Hose to the
Pumps
This procedure describes how to connect the fluid
output hoses to the two Pumps. It is the customer's
responsibility to have the fluid supply hose already
installed and ready for connection to the Pumps.
NOTE: For more information about the Pumps, see
Related Manuals on page 3 for the Pump instruction
manuals.
Fluid Outlet
F . 6
IG
18
NOTICE
There must be a minimum of 10 feet (3 m) of fluid
supply hose on the outlet to prevent damage to the
unit.
NOTE: The fluid supply hose must move freely without
kinking when the Pumps move up and down.
Check the fluid supply hose to ensure it is properly
sized and pressure-rated for this system. Use only
electrically conductive hoses. The fluid supply hose
should have spring guards on both ends. Connect the
fluid supply hose to the fluid manifold outlet.
Fluid Supply Hose
Fluid Manifold
Note: Models 246983 and 246984 do not
include "Y" manifold. Two hoses are
provided to connect to customer's rigid
plumping.
TI0139
309169ZAF