Hose - Graco EcoQuip 300 Operation, Repair, And Parts

Operation
Connecting the the Blast Blast Hose
Connecting Connecting the Blast

Hose

Hose Hose
1. Always purge the air supply hose 15–20 seconds
before connecting the air supply hose from the
compressor (or on-site compressed air source)
to the panel. Make sure all debris is cleared from
the hose.
2. Connect an appropriately sized air
supply hose to the air inlet. See
Technical Specifications, page
NOTE: Make sure to properly install hose
NOTE: NOTE:
restraints and coupler pins to the quick-coupler
and the air line. If the holes on the quick-coupler
do not align, there is something wrong and the
two couplers are not compatible. DO
ON THE ON ON THE AIR THE AIR. Seek help to get the situation AIR
resolved.
10
Hose and and Air Air
Hose and Air
45.
DO NOT DO NOT TURN NOT TURN TURN
Get other manuals https://www.bkmanuals.com
3. Open the air supply valve (125 psi, 8.6 Bar, 0.86
MPa maximum). If necessary, use a regulator in
the supply air line to meet these specifications.
NOTE: Make sure the air supply meets NOTE: NOTE:
the appropriate appropriate air appropriate air air flow flow flow requirements.
Technical Specifications, page
4. Connect the blast hose, hose restraints, control
hoses, and coupler pins.
NOTE: NOTE: If you are using an electric blast control, NOTE:
check all of the electrical connections from the
panel to the blast control.
NOTICE
NOTICE NOTICE
Make sure no electrical connections will
be exposed to water. Exposure to water
could cause a short circuit and damage the
equipment.
N
R U
F
O F T
A R
S T
requirements. See requirements.
45.
ti24706a
334667B