Warnings - Graco EcoQuip EQ200T Operation, Repair, And Parts

Warnings

Warnings Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific
risks. When these symbols appear in the body of this manual or on warning labels, refer back to these
Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout
the body of this manual where applicable.
DUST DUST DUST AND AND DEBRIS AND
Use of this equipment can result in the release of potentially harmful dust or toxic substances
from the abrasive being used, the coatings being removed, and the base object being blasted.
• For use only by sophisticated users familiar with applicable governmental safety and industrial
hygiene regulators.
• Use equipment only in a well-ventilated area.
• Wear a properly fit-tested and government approved respirator suitable for the dust conditions.
• Follow local ordinances and/or regulations for disposal of toxic substances and debris.
EQUIPMENT EQUIPMENT MISUSE EQUIPMENT
Misuse can cause death or serious injury.
• Do not operate the unit when fatigued or under the influence of drugs or alcohol.
• Do not exceed the maximum working pressure or temperature rating of the lowest rated
system component. See Technical
• Do not use this equipment without hose restraints and coupler pins installed on all air and
blast hose couplings.
• Do not blast unstable objects. The high amount of fluid flow from the nozzle can potentially
move heavy objects.
• Do not exceed load rating of lift eyes.
• Do not operate equipment on or stand on an unstable support. Keep effective footing and
balance at all times.
• Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data
in all equipment manuals. Read fluid and solvent manufacturer's warnings. For complete
information about your material, request MSDS from distributor or retailer.
• Do not leave the work area while equipment is energized or under pressure.
• Turn off all equipment and follow the Pressure
• Check equipment daily. Repair or replace worn or damaged parts immediately with genuine
manufacturer's replacement parts only.
• Do not alter or modify equipment. Alterations or modifications may void agency approvals
and create safety hazards.
• Make sure all equipment is rated and approved for the environment in which you are using it.
• Use equipment only for its intended purpose. Call your distributor for information.
• Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
• Do not kink or over bend hoses or use hoses to pull equipment.
• Keep children and animals away from work area.
• Comply with all applicable safety regulations.
334666C
WARNING WARNING WARNING
DEBRIS HAZARD DEBRIS HAZARD HAZARD
MISUSE HAZARD MISUSE HAZARD HAZARD
Technical Data
Technical
Data in all equipment manuals.
Data
Pressure Relief Relief Procedure Procedure when equipment is not in use.
Pressure Relief Procedure
Warnings
3