Bumper Stop Installation; Range Of Motion - Vulcan-Hart VMCS Series Operation And Field Installation Manual

Fig. 19
Fig. 20
Fig. 21
Raised Position
Lowered Position
17
- -
21. Install the bumper stop assembly into top
of armature. Fig. 19
Bumper Stop Assembly
22. Check range of motion as shown in
Fig. 20. The assembly should hold in
place at the raised, 53˚ position and rest
under its own weight in the lowered
position. Refer to page 6 for proper
raising and lowering technique.
23. Reinstall the top and rear spring
armature covers. Fig. 21
24. Repeat proceeding steps as needed for
each griddle top head assembly.