Advertisement
VHU Series Humidified and Heated Holding Cabinets
The VHU Series Humidified and Heated Holding Cabinets provide an efficient means of
holding bulk prepared foods at proper serving temperatures while maintaining food
quality. Advanced sensing technology maintains an ideal combination of temperature and
humidity, without complicated controls.
Vulcan Heated Holding Transport Cabinets are produced with quality workmanship and
material. Proper installation, usage, and maintenance of your cabinet will result in many
years of satisfactory performance. It is suggested that you thoroughly read this entire
manual and carefully follow all of the instructions provided.
Before installing, verify that the electrical
service agrees with the specifications on
the rating plate located toward the back
of the cabinet.
(Fig. 3)
equipment requirements do not agree, do
not
proceed
with
installation.
Contact your Vulcan-Hart
Customer
Service
immediately.
UNPACKING:
The Cabinet
was inspected before
leaving the factory. The transportation
company assumes full responsibility for
safe delivery upon acceptance of the
shipment. Immediately after unpacking,
check for possible shipping damage to
the cabinet.
If the cabinet is found to be damaged,
save the packaging material and
contact the carrier within 15 days of
delivery.
Carefully unpack and place in a work
accessible area as near the installation
position as possible.
1.
Open the door and carefully
remove any packaging materials
and the retaining straps that hold
the tray slides and tray slide
upright side supports.
2.
Peel off vinyl protection film.
INTRODUCTION
INSTALLATION
If the supply and
unpacking
and
Department
3.
STACKED
proceed to step 4 otherwise:
Stacked cabinets are stacked on
top of each other.
will come with casters and a
stacking assembly on top – this
is the bottom cabinet. The other
cabinet should be placed inside
the stacking kit and requires two
people to lift. Stacking kits fit only
one way between the cabinets. If
for any reason either one or both
cabinets do not fit within the
stacking
contact customer service.
4.
Remove universal tray slides from
box. Install tray slides in the
cabinet. Make sure the hook on
the end of the tray slide is up. (Fig.
1)
5.
Make sure the internal water pan
is located at the bottom of the
inner cavity. Install the second pan
underneath the unit on the 2 metal
slides. (Fig. 2)
4
Effective 03-16
UNITS
ONLY
One cabinet
kit
provided,
please
Fig. 1
–
Advertisement
