Siemens SIRIUS 3RW52 Manual page 47

Procedure with door mounting kit IP65
● Remove the protective film from the adhesive tape on the seal and secure the seal on the
rear side of the 3RW5 HMI Standard
Ensure that the seal does not overlap.
● Place the 3RW5 HMI Standard in the cutout of the control cabinet door
● Continue to screw the screws into the fixing brackets
10 mm at the front. Fasten the fixing brackets onto the 3RW5 HMI Standard
● Tighten the 3RW5 HMI Standard with a tightening torque of 0.3 ... 0.35 Nm
Ensure that all of the screw heads are in contact with the fixing bracket.
Ensure that the fixing brackets with marking "001" are used.
SIRIUS 3RW52 Soft Starter
Manual, 01/2019, A5E35630451002A/RS-AD/004
3.4 Installing / mounting / removing 3RW5 HMI
①
.
③
until they protrude approx.
Mounting and dismantling
②
.
④
.
⑤
.
47