Advertisement
5.1.1
Topology / Devices
The page Topology / Devices is the starting point for administering the measurements and device access.
The first steps are selection of the measurement devices and creation of the respective parameter set settings for
performing measurement.
In measurement operation, you are provided with an preview of the active measurement devices and the status of
every measurement running.
General procedure:
1. Make device definitions
2. Assign device in the topology
3. Create new parameter set or load an existing parameter set
4. Measure
Analysis
Variant 1
1. Load the last parameter set by means of the
Switch to analysis
2. Go to the analysis. There, all concluded measured data for this parameter set are displayed.
Variant 2
Go to the analysis and use the
5.1.1.1
Device definition
The upper table shows all devices which have previously been used, and enables more devices to be added.
The device status is indicated by various symbols.
Device is active
Device is active and is being parameterized at present
Total overview of all measurements
25
.
Find...
button to select a measurement location and data.
109
Operation modes and settings
Device definition
or using the Topology context menu item
22
Power Quality Recorder SICAM Q80 7KG8080, System manual
E50417-H1076-C420-A2, Release 12.01.2015
21
Advertisement
