Table of Contents
Advertisement
A
e
B
ec
D
e
Defining Function Keys (IBM Mode)
Press and hold the etrl key; then press the Def F key.
The function key menu should appear as shown below.
a
b
a: A two-digit number (01 through 36) of a function key is entered here.
b: The function is entered here (up to 64 characters).
In area a, type a two-digit key number and press the Send key.
In area b, type one or more ESe sequences, or a character
string; then press the Send key.
The defined function key is stored.
Repeat steps Band C until you have defined all necessary function keys.
To exit this mode, press and hold the etrl key; then press the Def
F key.
Notes:
1.
The display station can store up to 512 characters for all function-key
definitions.
If
the total exceeds 512, overflow characters are discarded, and
area a will blink at step C.
2.
If
you assigned more than
64
characters to a single function key by the host
command and display them in step B, area a will blink.
If
you have changed the
Chapter 2. Setup Procedures
2-37
Advertisement
Table of Contents
