Table of Contents
Advertisement
Introduction
Note: When you change the setup values after installation it is recommended
that you fIrst set the machine mode to the one whose vq.iues you want to change;
enter the setup menu and change the values. That is, if the current machine mode
(" '\
is IBM and you want
to
change the setup values for DEC, fIrst change the mode
~J
from-IBM to DEC by using the Machine Mode,Switch key; enter the setup menu.
If you enter the setup menu in IBM mode and change the setup values for DEC,
the machine mode changes as described in "Changing the Machine Mode" on
page 1-2 and IBM 3101 will become the new IBM mode when exiting the setup
menu.
Changing the Mode between IBM and DEC
In daily operation, you can switch the machine mode, for example, from
SYSTEM ATTACH to VT100 CONTROL 7 and vice versa, using the Machine
Mode Switch key as follows:
1. Sign off the current session.
2.
Press the Send key while holding down the Ctrl and Shift keys (Machine
Mode Switch key).
3.
Sign on the new session.
Warning: Do not press the Machine Mode Switch key without
first terminating the current session, otherwise the current session
will be suspended and will not operate correctly. If pressed by
mistake, press the Machine Mode Switch key again and sign off the
current session to clear the suspended state.
1-4
User's Guide for the Cartridge to Emulate IBM and DEC Terminals
Advertisement
Table of Contents
