Table of Contents
Advertisement
•
•
•
Step 12. Defining Setup Values
You must define the setup values so that the display station can correctly
communicate with the host system or printer. The person responsible for setting
up the display station should have selected the values for your installation.
"Setup Parameters List (emulation)" on page 3-23 lists all possible values for the
mode to emulate the DEC VT220. "Setup Parameters List (SYSTEM
ATTACH)" on page 3-30 lists all possible values for SYSTEM ATTACH mode.
"Setup Parameters List (IBM 3151/3101)" on page 3-32 lists all possible values
for IBM 3151 and IBM 3101 modes. The explanation of the values for the mode
to emulate the DEC VT220 is provided in "Setup Menus and Setup Values
(emulation)" on page 3-2. The explanation of the values for SYSTEM ATTACH
mode is provided in "Setup Menus and Setup Values (SYSTEM ATTACH)" on
page 3-25. The explanation of the values for IBM 3151 and 3101 modeS' is
provided in IBM 3151 ASCII Display Station Guide to Operations,
If you use only a DEC system, go to page 2-26 and do step 12A.
If you use only an IBM system, go to page 2-29 and do step 12B .
If you use both DEC and IBM systems, go to page 2-26 and do
steps 12A and 12B.
Note: The location of the Setup key in the mode to emulate the DEC VT220 and
other modes differs. For the location, see page 2-27 for the mode to emulate the
DEC VT220 and page 2-30 for other modes .
Chapter 2. Setup Procedures
2-25
Advertisement
Table of Contents
