Table of Contents
Advertisement
Flush-rear (recessed) mounting the device in the rack
Flush-rear (recessed) mounting the device in the rack
The flush-rear (recessed) mounting is similar to the flush-front mounting except that the brackets are reversed on the device.
CAUTION
The device must be turned off and disconnected from the fabric during this
procedure.
NOTE
Illustrations used in these rack installation procedures are for reference only and may not show the actual device that you are
installing.
Complete the following tasks to install the device in a four-post rack:
1.
Attaching the front brackets to the rear of the device
2.
Attaching the bracket extensions to the front of the device
3.
Installing the device in the rack
4.
Attaching the rear brackets to the bracket extensions at the front of the device
5.
Attaching the rear brackets to the front rack posts
Attaching the front brackets to the rear of the device
NOTE
In this installation, the brackets are named as listed in the parts list even though the installation of the brackets is reversed from
the flush-front installation.
Complete the following steps to attach the front brackets to the rear of the device.
1.
Position the right front bracket with the flat side against the right rear side of the device, as shown in
2.
Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket and then into the holes on the
side of the device. Use the upper and lower screw holes, leaving the center holes empty.
3.
Repeat
Step 1
and
44
on page 46
Step 2
to attach the left front bracket to the left rear side of the device.
on page 44
on page 45
on page 49
on page 47
Figure
ExtremeSwitching VDX 6740 Hardware Installation Guide
25.
9036108-00
Advertisement
Table of Contents
