Table of Contents
Advertisement
Installing the 1U, 1.5U, and 2U Mid-Mount Kit for Two-Post Racks (XBR-000165, XBR-000175, and XBR-R000292)
FIGURE 31 Rack kit parts
1.
Bracket, front right and back left
2.
Bracket, front left and back right
3.
Screw, 8-32 x 5/16-in., panhead Phillips (12)
Attaching the front brackets to the device
CAUTION
The device must be turned off and disconnected from the fabric during this
procedure.
Complete the following steps to attach the front brackets to the device.
1.
Position the right front bracket with the flat side against the right side of the device as shown in the following figure.
2.
Insert two 8-32 x 5/16-in. screws into one of the pairs of vertically aligned holes in the bracket and then into the vertical pair of
holes on the side of the device. To install the device in a recessed position in the rack, use the bracket holes that are set back
from the end of the bracket.
3.
Insert 8-32 x 5/16-in. screws through the rest of the holes in the bracket and into the corresponding holes in the device.
52
4.
Screw, 6-32 x 1/4-in., flathead Phillips (8)
5.
Screw, 10-32 x 5/8-in., panhead Phillips (8)
6.
Retainer nut, 10-32 (8)
ExtremeSwitching VDX 6740 Hardware Installation Guide
9036108-00
Advertisement
Table of Contents
