Table of Contents
Advertisement
Installing the 1U Slim Rail Rack Mount Kit for Four-
Post Racks (XBR-000291)
Use the following instructions to install a fixed-port device in a slim rail four-post configuration using the Slim Rail Rack Mount Kit for
Four-Post Racks (XBR-000291).
Observe the following when mounting this device:
•
Two people are required to install the device in a rack. One person holds the device, while the other screws in the front and rear
brackets.
•
Use Electronic Industries Association (EIA) standard racks.
•
Before mounting your device, review any specific installation and facility requirements in this Hardware Installation Guide.
•
Hardware devices illustrated in these procedures are only for reference and may not depict the device you are installing into the
rack.
Time and items required
Allow 15 to 30 minutes to complete this procedure.
Allow approximately one hour to unpack and install the device in a rack.
The following items are required to install a device using the slimline fixed rack mount kit:
•
Phillips #2 screwdriver with torque capability.
•
1/4 in. slotted-blade screwdriver with torque capability.
NOTE
You may need two people to install the device, one to support the device, while the other secures it into the rack.
CAUTION
The device must be turned off and disconnected from the fabric during this
procedure.
Parts List
The following parts are provided with the 1U Slim Rail Rack Mount Kit for Four-Post Racks (XBR-000291).
ExtremeSwitching VDX 6740 Hardware Installation Guide
9036108-00
Installing the 1U Slim Rail Rack Mount Kit for Four-Post Racks (XBR-000291)
31
Advertisement
Table of Contents
