Table of Contents
Advertisement
4.
Repeat step 1 through step 3 to attach the left rear bracket to the left front bracket.
FIGURE 17 Position the rear and front brackets
1.
Bracket, front right
2.
Bracket, rear right
Attaching the rear brackets to the rack rails
Complete the following steps to attach the rear brackets to the rack rails.
1.
Attach the right rear bracket to the right rear rack rail using two 10-32 x 5/8 in. screws and two retainer nuts as shown in the
following figure.
2.
Repeat step 1 to attach the left rear bracket to the left rear rack rail and tighten all the 10-32 x 5/8 in. screws to a torque of 25
in-lb (29 cm-kg).
3.
Provide power to the device by connecting the power cords to the power connectors on the device and a power outlet. Some
devices require you to flip a power device to be powered on.
Installing the 1U, 1.5U, and 2U Universal Kit for Four
Post Racks (XBR-R000295)
Use the following instructions to install a device in a 19-in. (48.3 cm) EIA rack using the 1U, 1.5U, and 2U Universal Kit for Four Post
Racks (XBR-R000295).
Observe the following when mounting this device:
•
The device can be installed so that the port side is either flush with the front posts or recessed with the non-port side flush with
the rear posts. A recessed position allows a more gradual bend in the fiber-optic cables connected to the device and less
interference in the aisle at the front of the rack.
ExtremeSwitching VDX 6740 Hardware Installation Guide
9036108-00
Installing the 1U, 1.5U, and 2U Universal Kit for Four Post Racks (XBR-R000295)
3.
Bracket, rear left
4.
Screw, 6-32 x 1/4 in., panhead Phillips (four per bracket)
35
Advertisement
Table of Contents
