Extreme Networks ExtremeSwitching VDX 6740 Hardware Installation Manual page 83

5. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 60 Attaching the rear brackets to a rack
1. Retainer nuts, 10-32
2. Rear brackets (right and left)
Attaching the rear brackets to the device
Complete the following steps to attach the rear brackets to the device.
1. Align the right rear bracket to the right rear of the device and use four 8-32 x 5/16-in. panhead screws to attach the bracket to
the device, as shown in
2. Align the left rear bracket to the left rear of the device and use four 8-32 x 5/16-in. panhead screws to attach the bracket to the
device. Again, use the upper and lower slots in the bracket.
ExtremeSwitching VDX 6740 Hardware Installation Guide
9036108-00
Figure 61. Be sure to insert the screws through the upper and lower slots in the bracket.
Installing the Universal Two-Post Rack Kit (XBR-R000294)
3. Screws, 10-32 x 5/8-in., panhead Phillips
83