Introduction; Electrostatic Discharge - Kodak M35 Service Manual

Overview
ESD--electrostatic discharge--is a primary source of:
• product downtime
• lost productivity
• costly repairs
While one cannot feel a static charge of less than
3,500 volts, as few as 30 volts can damage or
destroy essential components in electronic
equipment.
Effective ESD control requires following these
guidelines.
Personnel Awareness
Everyone within the organization needs to be aware
of ESD, because partial ESD control is no ESD
control at all. Please note:
• ESD is a primary source of
frustrating equipment failures and
intermittent malfunctions.
• ESD affects productivity and
profitability.
• ESD can be controlled.
General Precautions
• Do not store trash near static-sensitive equipment.
• Do not place plastic materials near electronic
components. Trash-can liners and styrofoam cups
generate static electricity, which can damage or
destroy electronic components.
981777

Introduction

Electrostatic Discharge

Preventive Measures
• Always look for an ESD warning label before doing
any procedure involving static-sensitive
components such as circuit boards. All
static-sensitive components are marked with bright
graphic labels, which frequently include
instructions. Follow all label instructions.
• If the work area is carpeted, spray the carpet with
an antistatic solution. In low-humidity
environments, spray carpets periodically with an
antistatic preparation, available at local stores.
• Wear a grounding strap when handling
static-sensitive components. Always make certain
that the clip remains attached to a properly
grounded, unpainted, clean surface.
• Repair static-sensitive components at an
ESD-protected work station or use a portable
grounding mat. For help in setting up an
ESD-protected work station, contact your Kodak
representative.
• When moving static-sensitive components from one
area to another, insert and transport the
components in ESD-protective packaging.
Transparent antistatic bags are available from a
variety of manufacturers and will help shield
components from ESD damage.
1-1