Replacement Of The Resilient Drive Roller In The Developer And Fixer Racks - Kodak M35 Service Manual

Replacement of the Resilient Drive Roller
in the Developer and Fixer Racks
[1] Remove the 2 SPRINGS from the top of the
RACK.
[2] Remove the SCREWS, WASHERS, LOCK
WASHERS, GEAR, SPACERS, and
BEARINGS from the resilient DRIVE ROLLER
on the outside of both SIDE PLATES.
[3] Rotate the flat part of the SHAFT to the up
position.
SCREW
WASHER
BEARING
SPACER
LOCK
WASHER
SPRING
non-drive
SIDE PLATE
981777
SPACER
SHAFT
Replacement of the Resilient Drive Roller
[4] Move the DRIVE ROLLER to the non-drive
side and remove the KEY from the
SPROCKET.
[5] Pull the SHAFT to the drive side to remove it
from the non-drive SIDE PLATE.
[6] Remove the THRUST WASHER, SPROCKET,
and SPACER.
[7] Continue to pull the SHAFT to the non-drive
side.
[8] Remove the DRIVE ROLLER.
[9] Reverse the procedure to install the new
DRIVE ROLLER.
DRIVE
ROLLER
SPROCKET
SPACER
drive
SIDE PLATE
SPRING
KEY
THRUST
WASHER
DRIVE
GEAR
KEY
SCREW
BEARING
WASHER
LOCK
WASHER
SPACER
H112_0106DCA
H112_0106DA
2-13