Adjustment for Squareness
Use this procedure to check the
squareness of any of the
CROSSOVER ASSEMBLIES.
[1]
Remove the CROSSOVER ASSEMBLY from
the processor.
[2]
Place the CROSSOVER ASSEMBLY on a
smooth, flat surface.
[3]
Loosen the 2 NUTS on the 2 TIE RODS.
[4]
Check that the 2 SIDE PLATES touch the flat
surface evenly.
[5]
Tighten the 2 NUTS.
Installation of a New Guide Shoe
[1]
Remove the existing GUIDE SHOE SCREWS
and GUIDE SHOE.
[2]
Install the GUIDE SHOE with the LONG TIPS
in the direction of film travel.
[3]
Install the 2 GUIDE SHOE SCREWS.
The GUIDE SHOES have no adjustment procedures.
SIDE
PLATE
GUIDE SHOE
SCREW (2)
TIE ROD
2-6
Crossover Assemblies
NOTE
NOTE
LONG TIP
LONG
TIP
Installing a Guide Shoe
TIE ROD
NUT
GUIDE
SHOE
SHORT
TIP
H048_0155CCB
H048_0155CA
NUT
SIDE PLATE
H112_0056BCA
H112_0056BA
981777