Replenishment Pump; Replacement Of The Replenishment Pump - Kodak M35 Service Manual

Replenishment Pump

Replacement of the Replenishment Pump

Dangerous voltage.
[1] Disconnect the main power.
[2] Disconnect the water supply.
[3] Remove the:
• TOP COVER
• 2 SIDE PANELS
• RECEIVING BIN
• DRYER TEMPERATURE CONTROL KNOB
• PUMP COVER
• EXIT PANEL
[4] Disconnect the 2 MOTOR LEADS TB3-6 and
TB3-2 and the ground wire.
[5] Clamp the REPLENISHER TUBE.
[6] Remove the REPLENISHER TUBE LINES from the REPLENISHMENT PUMP.
[7] Remove and keep the 2 SCREWS, the 2 WASHERS, and the 2 LOCK WASHERS.
[8] Remove the REPLENISHMENT PUMP.
[9] Reverse the above procedure to install a new REPLENISHMENT PUMP.
REPLENISHMENT
PUMP (2)
WASHER (2)
LOCK
WASHER (2)
2-36
SCREW (2)
Replacement of a Replenishment Pump
TOP COVER
EXIT PANEL
PUMP
COVER
DRYER
TEMPERATURE
CONTROL KNOB
SIDE PANEL (2)
H112_0115ACB
H112_0115AC
REPLENISHER
TUBE LINES
H112_0097BCA
H112_0097BA
981777