IBM e Server i Series Manual page 55

__ 24. DANGER
To prevent a possible electrical shock from touching two surfaces with
different electrical grounds, use one hand, when possible, to connect
or disconnect signal cables. (RSFTD004)
Reconnect any cables and label the cables with the card position.
__ 25. Place the expansion unit and system unit side-by-side.
__ 26. Position the left side of the system expansion unit slightly ahead of the
right side of the system unit.
__ 27. The left side of the system expansion unit has connector hooks that must
engage in the slots on the right side of the system unit frame.
__ 28. Slide the expansion unit back, engaging the connector hooks, until the
units are aligned.
__ 29. Install the two thumbscrews B to secure the expansion unit to the system
unit. Install the thumbscrews from the expansion unit side.
__ 30. Locate the data cable, part number 04N2273. Plug the end of the cable
(opposite the white cable retainers) into the lower disk unit enclosure.
__ 31. Thread the cables, from the expansion unit, through the openings.
A
Disk unit data cables (part number 04N2273)
C
Air moving device cable (part number 04N5720)
Install the 7104 expansion unit to the 270 server or 7116 expansion unit to the 800 or 810 server
49