IBM e Server i Series Manual page 19

__ a. Type strsst on the command line of the iSeries session and press
Enter.
__ b. Select Work with disk units from the System Service Tools (SST)
display. Press Enter.
__ c. Select Work with disk unit recovery from the Work with Disk Units
display. Press Enter.
__ d. Does the disk unit that you replaced have device parity protection
(RAID)?
__ No: The disk unit you replaced had mirrored protection. Go
to step 26.
__ Yes: Follow these steps:
__ 1) Select Rebuild disk unit data on the Work with Disk
__ 2) Select 1 to rebuild the disk unit displayed (disk unit
__ 3) Press Enter on the Confirm Rebuild Disk Unit Data
__ 4) Install the disk unit covers. Align the tabs on the disk
__ 5) Install or close the system unit or expansion unit front
__ 6) Press F5 to refresh the display until the Percent
__ 7) When the display shows at least 5% complete, you can
__ 8) Press F3 (Exit) to return to the System service tools
__ 9) Press F3 (Exit) to return to the exit SST display and
__ 26. The disk unit you replaced had mirrored protection. Follow these steps:
__ a. Select Replace configured unit on the Work with Disk unit recovery
display.
Press Enter.
__ b. Select the configured disk unit that you are exchanging (suspended
unit) on the Select Configured Unit to Replace display. There should be
only one unit available.
Press Enter.
__ c. Select the disk unit that you just installed on the Select Replacement
Unit display. This unit has a non-configured status.
Note: In some cases, it may take several minutes for a new disk unit
to display. Repeat these steps until the new unit appears.
unit recovery display.
Press Enter.
displayed is the disk unit that you removed) on the
Rebuild Disk Unit Data display.
Press Enter.
display. The rebuild process may take several minutes
to complete.
unit cover with the slots in the system unit. Push the
cover in until it latches.
cover.
complete shows 5%.
either continue to monitor this display to completion, or
press F3 (Exit) to return to the Work with disk units
display.
display.
press Enter.
The replacement procedure is complete.
Chapter 2. Replace 43xx disk units
13