IBM e Server i Series Manual page 12

__ 21. Support the bottom of the disk unit assembly as you slide it half way into
__ 22. The physical locations you entered in step 11 on page 4 of this procedure
__ 23. Select option 2 (Install device) for the action to be performed.
__ 24. Set the time delay for one minute—01. Do not press Enter at this time.
__ 25. Press Enter on the console.
__ 26. When the light starts blinking, slide the disk unit all the way in and then
__ 27. The light stops blinking and remains on when you have installed the disk
__ 28. Return to the console and wait until the Concurrent Maintenance Results
__ 29. When the Hardware Service Manager display appears, press F3.
__ 30. Select Work with Disk Units on the System Service Tools display.
6
43xx Disk Unit, 71xx Disk Expansion Unit, 71xx Disk Unit Enclosure V5R3
the system unit or the expansion unit. Do not push it any further.
Note: You install the disk units horizontally in the 7123, 7136, and 7137
disk unit enclosure.
may still appear on the display. If not, retype the Physical Location (Frame
ID and position) where you will be installing the new disk unit.
In this example, Physical Location: Frame ID 1____ Position D06____ ,
you would install a disk unit in frame 1 (base system), disk unit position 6.
Note: Locate the light in the numbered arrow by the disk unit you are
replacing. When you press Enter, after a one minute delay, this light
comes on and begins to blink rapidly. You then have nine seconds to
slide the disk unit into place.
lock it in place by closing the latch.
unit properly.
display appears.
Press Enter.
Press Enter.