IBM e Server i Series Manual page 13

__ 31. Select Work with disk unit recovery on the Work with Disk Units display.
Press Enter.
__ 32. Does the disk unit that you replaced have device parity protection
(RAID)?
__ No: The disk unit you replaced had mirrored protection. Go to step
33.
__ Yes: Follow these steps:
__ a. Select Rebuild disk unit data on the Work with Disk unit
recovery display.
Press Enter.
__ b. Select 1 to rebuild the disk unit displayed (disk unit displayed
is the disk unit that you removed) on the Rebuild Disk Unit
Data display.
Press Enter.
__ c. Press Enter on the Confirm Rebuild Disk Unit Data display. The
rebuild process may take several minutes to complete.
__ d. Install the disk unit covers. Align the tabs on the disk unit
cover with the slots in the system unit. Push the cover in until
it latches.
__ e. Install or close the system unit or expansion unit front cover.
__ f. Press F5 to refresh the display until the Percent complete
shows 5%.
__ g. When the display shows at least 5% complete, you can either
continue to monitor this display to completion, or press F3
(Exit) to return to the Work with disk units display.
__ h. Press F3 (Exit) to return to the System service tools display.
__ i. Press F3 (Exit) to return to the exit SST display and press Enter.
The replacement procedure is complete.
__ 33. The disk unit you replaced had mirrored protection. Follow these steps:
__ a. Select Replace configured unit on the Work with Disk unit recovery
display.
Press Enter.
__ b. Select the configured disk unit that you are exchanging (suspended
unit) on the Select Configured Unit to Replace display. There should be
only one unit available.
Press Enter.
__ c. Select the disk unit that you just installed on the Select Replacement
Unit display. This unit has a non-configured status.
Note: In some cases, it may take several minutes for a new disk unit
to display. Repeat these steps until the new unit appears.
Press Enter.
__ d. Press Enter on the Confirm Replace of Configured Unit display to
confirm your choice for replacement.
The replacement process may take several minutes to complete.
When the process is complete, the Work with Disk unit recovery
display appears.
__ e. Press F3 (Exit) to return to the Work with disk units display.
__ f. Select Display disk configuration on the Work with disk units display.
Chapter 2. Replace 43xx disk units
7