IBM e Server i Series Manual page 28

__ 3. Support the bottom of the disk unit assembly as you slide it completely
__ 4. Align the disk unit assembly with the next available slot and slide it into
__ 5. Close the disk unit handle firmly locking it into place.
__ 6. Do you have another disk unit to install?
__ 7. Install the disk unit covers. Align the tabs on the disk unit enclosure cover
__ 8. Do you have any other adapter cards or devices to install?
__ 9. Remove the disposable wrist strap.
__ 10. Install or close the unit front cover.
22
43xx Disk Unit, 71xx Disk Expansion Unit, 71xx Disk Unit Enclosure V5R3
forward and install it into the system unit or the expansion unit. Do not
hold the disk unit by the handle.
the system or expansion unit until it stops. Make sure that the handle is
fully extended when sliding into the system unit or the expansion unit.
__ No: Continue with the next step.
__ Yes: Repeat this procedure to install the next disk unit.
with the slots on the system unit enclosure. Push the cover in until it
latches.
__ No: Continue with the next step.
__ Yes: If you have another device such as an adapter card, a tape unit,
or a memory card to install, go to the instructions that came with
that device.