IBM e Server i Series Manual page 52

__ 9. Remove the back cover. Refer to "Remove the side and back cover" on
__ 10. Remove the right side cover (two thumbscrews).
__ 11. Remove the left side cover (two screws).
__ 12. Remove the top cover (two screws). Slide the top cover back and lift up.
__ 13. If possible, use a wrist strap to prevent electrostatic discharge from
__ 14. Did you receive a 2757, 2763, 2782, 4748, 4778, 5703, or 5705 IOA card?
__ 15. Locate the adapter card positions inside your system unit.
__ 16. Does your unit have screws to secure the cards?
46
43xx Disk Unit, 71xx Disk Expansion Unit, 71xx Disk Unit Enclosure V5R3
page 69.
damaging your hardware. If you do not have a wrist strap, touch a metal
surface of the system or expansion unit before installing or replacing
hardware.
If you received the 2209 Disposable Wrist Strap, follow these steps:
__ a. Attach the disposable wrist strap.
__ b. When you unroll the strap, remove the liner from the copper foil at
the end.
__ c. Attach the adhesive part of the copper foil to an exposed, unpainted
metal surface on the frame of the unit.
Note: Follow the same precautions you would use without the wrist strap.
The 2209 Disposable Wrist Strap is for static control. It will not
increase or decrease your risk of receiving electric shock when using
or working on electrical equipment.
If no, go to step 25 on page 49.
If yes, use the following table to determine where to install the IOA card.
Card received Current position
C01
2763 or 2782, 5703, or 9767
5705
2763
2757, 4748, 4778 9767
2763
View video.
Action needed
Install 2763, 2782, 5703, or 5705 in position C02
Install new 2763, 2782, 5703, or 5705 in position
C02
Remove 9767 and install 2757, 4748, or 4778 in
position C01
Remove 2763 and install 2757, 4748, or 4778 in
position C01