IBM e Server i Series Manual page 17

__ 12. Make sure that the disk unit handle is fully extended when sliding into the
system unit or the expansion unit. Support the bottom of the disk unit
assembly as you slide it into the system unit or the expansion unit until it
stops.
__ 13. Close the disk unit handle firmly locking it into place.
__ 14. Install the disk unit covers. Align the tabs on the disk unit enclosure cover
with the slots on the system unit enclosure. Push the cover in until it
latches.
__ 15. Install or close the unit front cover.
__ 16. DANGER
An electrical outlet that is not correctly wired could place hazardous
voltage on metal parts of the system or the products that attach to the
system. It is the customer's responsibility to ensure that the outlet is
correctly wired and grounded to prevent an electrical shock.
(RSFTD201)
Plug the following power cords into an electrical outlet.
v System unit
v System unit console
v Expansion units
__ 17. Plug in and power on all attached devices, such as printers and displays.
__ 18. If your system unit is an iSeries 270, 800, or 810, go to step 20.
__ 19. If your system unit is an iSeries 820, 825, 830, 840, 870 or 890, go to step 22
on page 12.
__ 20. Look at the Function/Data display on the control panel. Refer to
"System-unit control panel" on page 43.
__ 21. Does 01 B N V=S appear in the Function/Data display?
Chapter 2. Replace 43xx disk units
11