Suzuki Wagon R Manual page 2841

4A-8 FRONT DRIVE SHAFT (G10/M13 ENGINE MODELS)
c) Remove cage (1) with retaining ring (2) from housing (3) if
necessary.
3) Remove differential side boot small band, and then pull out
differential side boot from shaft.
4) Pull out damper through shaft.
5) Remove wheel side boot big band (1) as follows.
• For boot big band without joint
Cut boot big band using a iron saw or a nipper with care not
to damage wheel side joint housing.
• For boot big band with joint
Draw hooks of boot big band together and remove band.
6) Remove wheel side small band, and then pull out wheel side
boot from shaft.
[A]: For boot big band without joint
[B]: For boot big band with joint
For tripod joint type
CAUTION:
• Disassembly of wheel side joint is not allowed. If noise
or damage exists in it, replace it as assembly.
• Do not disassemble tripod joint spider. If any malcon-
dition is found in it, replace it as differential side joint
assembly.