Suzuki Wagon R Manual page 2763

1B-12 AIR CONDITIONING (OPTIONAL)
Compressor Drive Belt
NOTE:
For G10 engine model, refer to the same section of the
Service Manual mentioned in the "FOREWORD" of this
service manual.
Inspection
M13 Engine Model
• Check compressor drive belt (6) for wear and cracks, and
replace as required.
• Check compressor drive belt (6) tension by measuring how
much it deflects when pushed at intermediate point between
compressor pulley (1) and tension pulley (2) with about 100
N (10 kg, 22 lbs) force after crankshaft pulley 1 rotating. If
belt tension is without specification, adjust belt tension refer-
ring to below procedures.
Compressor drive belt tension
"a": 3 – 5 mm (0.12 – 0.20 in.)
New compressor drive belt tension
"a": 2 – 4 mm (0.08 – 0.16 in.)
Z13DT Engine Model
Refer to "Water Pump / Generator Drive Belt Removal and Instal-
lation" in Section 6B3.
Adjustment
M13 Engine Model
1) Loosen tension pulley nut (3).
2) Adjust belt tension by tighten or loosen tension pulley adjust-
ing bolt (4).
3) Tighten tension pulley nut (3).
4) Turn the crank pulley (5) 1 revolution, then check belt ten-
sion.
Z13DT Engine Model
Refer to "Water Pump / Generator Drive Belt Removal and Instal-
lation" in Section 6B3.
Replacement
M13 Engine Model
1) Loosen tension pulley nut (3).
2) Loosen belt tension by loosen tension pulley adjusting bolt
(4).
3) Remove compressor drive belt (6).
4) Install new compressor drive belt.
5) Adjust belt tension referring to above procedure.