Suzuki Wagon R Manual page 2798

• Apply grease lightly to contact part (1) of wheel bearing and
drive shaft.
"A": Grease 99000-25050
2) Install knuckle (2) to ball stud (3) on suspension control arm
(4) and strut bracket (1). Installing direction of each bolt is as
shown.
Align knuckle bolt hole with ball stud groove and install con-
trol arm ball stud bolt (5). Tighten each bolt and nuts to spec-
ified torque.
Tightening torque
Strut bracket bolt (a): 115 N
Control arm ball stud bolt (b): 60 N
F. Forward
3) Install wheel speed sensor (if equipped).
4) Connect tie-rod end (1) to knuckle (2) and install new tie-rod
end nut.
Tighten tie-rod end nut (3) to specified torque.
Tightening torque
Tie-rod end nut (c): 40 N
5) Tighten new drive shaft nut temporarily.
FRONT SUSPENSION 3D-11
·
m (11.5 kg-m, 83.5 lb-ft)
·
m (6.0 kg-m, 43.5 lb-ft)
·
m (4.0 kg-m, 29.0 lb-ft)