Suzuki Wagon R Manual page 2768

Receiver / Dryer
Removal
Z13DT Engine Model
1) Recover refrigerant from refrigeration system by using recov-
ery and recycling equipment.
NOTE:
The amount of removed compressor oil must be mea-
sured for replenishing compressor oil.
2) Remove A/C condenser assembly referring to A/C con-
denser assembly in this section.
3) Loosen receiver / dryer attachment bolt (1), (2).
4) Remove receiver / dryer (3).
M13 and G10 Engine Models
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.
Installation
Z13DT Engine Model
Reverse removal sequence to install receiver / dryer noting the
following points.
• If receiver / dryer (3) is replaced, pour 20 cc of refrigerating
oil to compressor suction-side.
• Evacuate and charge system according to previously
described procedure.
M13 and G10 Engine Models
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.
AIR CONDITIONING (OPTIONAL) 1B-17