Suzuki Wagon R Manual page 2770

1
3
7
5
2
4
1
6) Loosen suction hose & liquid pipe bolt (4).
7) Loosen cooling unit bolt (1), nut (2) and screw (3) as shown
in figure.
8) Remove cooling unit (5).
M13 and G10 Engine Models
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.
Installation
Z13DT Engine Model
Reverse removal sequence to install cooling unit, noting the fol-
lowing points.
• If cooling unit or evaporator is replaced, pour 25 cc of refrig-
erating oil to compressor suction-side.
• Install uniformly the padding (1) to installation hole.
• Evacuate and charge system according to previously
described procedure.
• Adjust heater control cable, referring to "Heater Control
Lever Assembly" in Section 1A.
• Enable air bag system, if equipped.
M13 and G10 Engine Models
Refer to the same section of the Service Manual mentioned in the
"FOREWORD" of this service manual.
Dual Pressure Switch (M13 and G10 Engine
Models)
Removal
1) Recover refrigerant from refrigeration system by using recov-
ery and recycling equipment.
2) Disconnect negative (–) cable at battery.
3) Remove dual pressure switch.
AIR CONDITIONING (OPTIONAL) 1B-19