Suzuki Wagon R Manual page 2775

1B-24 AIR CONDITIONING (OPTIONAL)
1
Installation
Reverse removal procedure to install compressor noting the fol-
lowing instructions.
• If compressor is replaced, pour new compressor oil by refer-
ring to "Replenishing Compressor Oil" under "Compressor"
in this section.
• Evacuate and charge system by referring to "Recovery" in
this section.
• Adjust drive belt tension by referring to "Compressor Drive
Belt" in this section.
Replenishing Compressor Oil
Z13DT Engine Model
It is necessary to replenish specified amount of compressor oil to
2
compressor (1) from compressor suction side hole (2) before
evacuating and charging refrigerant.
When Charging Refrigerant Only
When evacuating and charging refrigerant without replacing any
component part, replenish the same amount of measured oil
when recovering refrigerant (if not measured, replenish 30 cc oil).