Table of Contents
Advertisement
2. Configure the service processor. See
Management Port" on page
3. Commit the changes to the service processor parameters. See
Configure the Service Processor Network Management Port" on page
You can now use the network management port at any time to access the service
processor. See
"To Log Into the Service Processor Using the Network Management
Port" on page
50.
Logging Into the Service Processor
If you are powering on the system for the first time after installation, use the service
processor serial port to power on the system and run POST. See
Service Processor Using the Serial Management Port" on page
If the network management port has already been configured, you can use it instead
of the serial management port. See
Network Management Port" on page
To Log Into the Service Processor Using the
▼
Serial Management Port
After the service processor boots, access the ILOM CLI to configure and manage the
system. The ILOM CLI prompt (->) is displayed at the first time the service
processor is booted. The default configuration provides an ILOM CLI root user
account. The default root password is changeme. Change the password using the
service processor ILOM CLI password command.
"To Configure the Service Processor Network
47.
"To Log Into the Service Processor Using the
50.
Chapter 3 Powering On the System
Step 5
in
"To
47.
"To Log Into the
45.
45
Advertisement
Table of Contents
