Table of Contents
Advertisement
Sections of the Slide Rail Assembly on the SPARC Enterprise T5240 Server
FIGURE 1-7
1
Figure Legend
1
Mounting bracket
2
Front section
The front, middle, and rear sections form the slide rail. The middle and rear sections
■
have holes for mounting screws, and adjust to fit rack depths from 24 in. (61 cm)
to 36.5 in. (93 cm). The front section can be extended to allow movement of the
server out of the rack.
The removable mounting bracket slides 14 in. (35.5 cm) out of the slide rail, then
■
locks in place. If you unlock the mounting bracket at this point, it slides an
additional 12 in. (30 cm) before separating from the slide rail. You can then mount
the mounting bracket to the right or left side of the server chassis.
Note that there are a total of five locks (
■
are on the mounting bracket. One lock is on the front section of the slide rail. The
installation procedure in
2
3
4
3
Middle section
4
Rear section
FIGURE 1-8
Chapter 2
describes the uses of these locks.
Chapter 1 Preparing for Installation
) in a slide rail assembly. Four
11
Advertisement
Table of Contents
