Enabling The Service Processor Network Management Port - Fujitsu Siemens Computers SPARC Enterprise T5140 Installation Manual

Enabling the Service Processor Network
Management Port
The service processor network management port is not operational unless your
network employs DHCP, in which case the configuration in automatic. If you
network uses DHCP, you can run this command
-> show /SP/network
to view your server's network configuration information. For example,
-> show /SP/network
/SP/network
If your network does not use DHCP, the network management port is not
operational until you configure network settings for the service processor. Configure
the service processor in this order:
1. After the service processor boots, access the ILOM CLI through the serial
management port. See
Management Port" on page
44 SPARC Enterprise T5140 and T5240 Servers Installation Guide • February 2008
Targets:
Properties:
commitpending = (Cannot show property)
dhcp_server_ip = 10.8.31.5
ipaddress = 10.8.31.188
ipdiscovery = dhcp
ipgateway = 10.8.31.248
ipnetmask = 255.255.252.0
macaddress = 00:14:4F:7E:83:4F
pendingipaddress = 10.8.31.188
pendingipdiscovery = dhcp
pendingipgateway = 10.8.31.248
pendingipnetmask = 255.255.252.0
state = enabled
Commands:
cd
set
show
"To Log Into the Service Processor Using the Serial
45.