Fujitsu Siemens Computers SPARC Enterprise T5140 Installation Manual page 74

a. If you choose to use a dynamically created IP address (use DHCP to retrieve
-> set /SP/network pendingipdiscovery=dhcp
Set 'pendingipdiscovery' to 'dhcp'
a. If you choose to configure a static IP configuration. set the parameters
-> set /SP/network pendingipdiscovery=static
Set 'pendingipdiscovery' to 'static'
-> set /SP/network pendingipaddress=service-processor-IPaddr
Set 'pendingipaddress' to 'service-processor-IPaddr'
-> set /SP/network pendingipgateway=gateway-IPaddr
Set 'pendingipgateway' to 'gateway-IPaddr'
-> set /SP/network pendingipnetmask=255.255.255.0
Set 'pendingipnetmask' to '255.255.255.0'
This example uses 255.255.255.0 to set the netmask. Your network
environment subnet might require a different netmask. Use a netmask number
most appropriate to your environment.
4. Use the show /SP/network command to verify that the parameters were set
correctly.
CODE EXAMPLE 3-1
processor from a dhcp configuration to a static configuration
CODE EXAMPLE 3-1
-> show /SP/network
/SP/network
48 SPARC Enterprise T5140 and T5240 Servers Installation Guide • February 2008
the network setting), set pendingipdiscovery to dhcp.
pendingipdiscovery, pendingipaddress, pendingipgateway, and
pendingipnetmask as follows.
i. Set the service processor to accept a static IP address.
ii. Set the IP address for the service processor.
iii. Set the IP address for the service processor gateway.
iv. Set the netmask for the service processor.
shows parameters that have been set to convert a service
show /SP/network Command Output
Targets: