Block %2 Leading Axis/Spindle %3 Max No Of Cp Master Values Exceeded; Block %2 Following Already Defined In Channel %4 - Siemens Sinamics S120 Diagnostic Manual

16672 [Channel %1: ] Block %2 leading axis/spindle %3 maximum number of CP master
values (%4) exceeded
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Max. number of CP master values
Definitions: An attempt was made to activate more master values of generic couplings than are configured in MD18452
$MN_MM_NUM_CP_MODUL_LEAD.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Reduce the number of defined or active master values, or increase the total number of master values configured in
MD18452 $MN_MM_NUM_CP_MODUL_LEAD.
If necessary, buy another option stage of the generic coupling.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16673 [Channel %1: ] Block %2 leading axis/spindle %3 maximum number of CP master
values (%4) exceeded
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Max. number of CP master values
Definitions: An attempt was made to activate more master values of generic couplings than are configured in MD18452
$MN_MM_NUM_CP_MODUL_LEAD.
Reaction: NC not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Reduce the number of defined or active master values, or increase the total number of master values configured in
MD18452 $MN_MM_NUM_CP_MODUL_LEAD.
If necessary, buy another option stage of the generic coupling.
Program Clear alarm with the RESET key in all channels. Restart part program.
Continuation:
16675 [Channel %1: ] block %2 following axis/spindle %3 coupling module already defined in
channel %4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis/spindle
%4 = Channel number
Definitions: An attempt was made to define or activate a CP coupling, although a coupling had already been defined or activated
on this following axis/spindle in another channel.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Change the part program: A CP coupling module must not be simultaneously defined in multiple channels for the same
following axis/spindle.
Program Clear alarm with the RESET key. Restart part program
Continuation:
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
NCK alarms
229