Tm54F: Internal Software Error; Tm: Calibration Data; Tm: Temperature Fault/Alarm Threshold Channel 1 Exceeded - Siemens Sinamics S120 Diagnostic Manual

235152 <location>TM54F: Internal software error
Message value: %1
Drive object: AFE_SINUMERIK_828, BIC_SINUMERIK_828, SERVO_COMBI, SERVO_SINUMERIK828, SIC_COMBI,
SIC_SINUMERIK_828, TM54F_MA, TM54F_SL
Reaction: NONE
Acknowledge: IMMEDIATELY
Cause: An internal software error has occurred in the Terminal Module 54F (TM54F).
The fail-safe digital inputs and digital outputs (F-DI, F-DO) on the TM54F have been set to the safe state.
Note:
F-DI: Failsafe Digital Input
F-DO: Failsafe Digital Output
Remedy: Check that the firmware version of the TM54F matches the Control Unit's firmware version.
The automatic firmware update must be activated in the project.
Note:
This signal will also appear, for example, in conjunction with signal 35013. In this case you should check all the param-
eters for the test stop on the TM54F (p10001, p10003, p10007, p10041, p10046, p10047).
235200 <location>TM: Calibration data
Message value: %1
Drive object: AFE_SINUMERIK_828, BIC_SINUMERIK_828, SERVO_COMBI, SERVO_SINUMERIK828, SIC_COMBI,
SIC_SINUMERIK_828, TM120
Reaction: NONE
Acknowledge: NONE
Cause: An error was detected in the calibration data of the Terminal Module.
Alarm value (r2124, interpret decimal):
The hundred-thousands and ten-thousands position specifies the component ID of the Terminal Module which
detected the fault.
The thousands location specifies whether the analog input 0 (=0) or analog output 1 (= 1) is involved.
The hundreds location specifies the fault type:
0: No calibration data available.
1: Offset too high (> 100 mV).
The tens and ones location specifies the number of the input involved.
Remedy: Power down the unit and power up again.
If the fault is still present, replace the module/board.
235207 <location>TM: Temperature fault/alarm threshold channel 1 exceeded
Message value: %1
Drive object: AFE_SINUMERIK_828, BIC_SINUMERIK_828, SERVO_COMBI, SERVO_SINUMERIK828, SIC_COMBI,
SIC_SINUMERIK_828, TM120
Reaction: Servo: OFF2 (NONE, OFF1, OFF3)
Infeed: OFF2 (NONE, OFF1)
Acknowledge: IMMEDIATELY (POWER ON)
Cause: For the temperature evaluation via the Terminal Module (TM), at least one of the following conditions to initiate this
fault is fulfilled:
- alarm threshold has been exceeded longer than that set in the timer stage (p4102[0], p4103[0]).
or
- fault threshold exceeded (p4102[1]).
Alarms
Diagnostics Manual, 07/2010, 6FC5398-8BP40-0BA0
SINAMICS alarms
855