Siemens Simatic Ident Function Manual page 74

Setting parameters for blocks
3.5 Programming the Ident profile
Table 3- 53 Output parameter
Output parameter
DONE
ERROR
STATUS
WARNING
BUSY
RPTACT
ERR_IREQ
TPC
TP
74
Data type Default value
BOOL FALSE
BOOL FALSE
DWORD FALSE
BOOL FALSE
BOOL FALSE
BOOL FALSE
BOOL FALSE
BOOL FALSE
BOOL FALSE
Meaning
TRUE = Command was executed free of errors.
TRUE = Error was detected.
The error is output in the "STATUS" parameter. The bit is
reset automatically when a new command is started.
Warning and error
If "ERROR = TRUE" or "WARNING = TRUE", the error or
warning information is contained in the "STATUS" parame-
ter. For more information, refer to the section "Error mes-
sages (Page 121)".
TRUE = Warning was detected.
The warning is output in the "STATUS" parameter. If the
"ERROR" parameter is not set at the same time, the data
was correctly processed. The bit is reset automatically when
a new command is started.
TRUE = the block is executing a command.
Other commands except for "INIT" and "SRESET" cannot
be started.
TRUE = "RPTCMD" is active
The acknowledgment bit shows that the "Repeat mode" of
the CM/reader is active.
TRUE = An error has occurred on the communications
module or reader (e.g. on start-up of the reader, connection
termination or with RF61xR, RF68xR on antenna errors or
configuration changes)
Transponder Presence Changed (only when Pres-
ence_Mode is active)
TRUE = A new transponder enters the antenna field of the
reader or a transponder has left the antenna field.
The parameter is set to "FALSE" after the successful execu-
tion of the next "INVENTORY" (0x80, 0x81, 0x87) or "INIT"
command.
Transponder Presence
TRUE = There is a transponder in the antenna field of the
reader.
Ident profile and Ident blocks, standard function for Ident systems
Function Manual, 10/2018, C79000-G8976-C387-04