Sony DNW-7/7P Operation Manual page 46

!• REMOTE (remote control) connector (6-pin)
Connect the RM-P9 Remote Control Unit (not supplied) or VA-DN1
Camcorder Interface Adaptor (not supplied) to this connector.
2
By connecting a camcorder interface adaptor, you can control the VTR
from a 9-pin remote control device.
Notes
• When the RM-P9 Remote Control Unit is connected, the setup menu is
displayed on the monitor, regardless of the internal board setting.
• If the REMOTE and TEST OUT connectors are used at the same time,
it may not be possible to generate video signals at standard levels.
!ª VIDEO OUT (video output) connector (BNC type)
This connector outputs a composite signal (standard level, 75-ohm
terminated) to the video monitor. If the video monitor is connected here,
you can monitor the picture being shot by the camcorder as well as the
picture recorded by the VTR. When synchronizing the time code of an
external VTR with that of the camcorder, connect this connector to the
video input connector of the external VTR.
2-22
Chapter 2 Locations and Functions of Parts and Controls