Sony DNW-7/7P Operation Manual page 32

4 AUDIO LEVEL CH-1/CH-2 (audio channel 1 and channel 2
recording level) controls
These controls adjust the audio level of channels 1 and 2 when you set
2
the AUDIO SELECT CH-1/CH-2 switches to MANUAL.
5 AUDIO SELECT CH-1/CH-2 (audio channel-1 and channel-2
select) switches
These switches set the audio level adjustment for channels 1 and 2 to
MANUAL or AUTO.
6 AUDIO IN (audio input) switches
These switches select the audio input signals for audio channels 1 and 2.
The input signal source is one of:
FRONT: The input signal source is the MIC IN connector.
REAR: The input signal source is the AUDIO IN CH-1/CH-2
connectors.
WIRELESS: The input signal source is a WRR-855A UHF Synthesized
Tuner Unit (not supplied).
The audio input signals from the MIC IN connector and the wireless
microphone are always recorded on audio channels 3 and 4, respectively,
whether or not they are recorded on audio channels 1 and 2 in
accordance with the setting of this switch.
For more infomration, refer to the Maintenance Manual.
7 AUDIO OUT (audio output) connector (XLR type, 5-pin, male)
This connector outputs the stereo sound.
Using a CCXA-53 Audio Cable (not supplied), you can convert from a
5-pin connection to two 3-pin connections.
2-8
Chapter 2 Locations and Functions of Parts and Controls