Sony DNW-7/7P Operation Manual page 149

The last page accessed appears in the viewfinder display. When this
menu is first used, the lowest-numbered on of the currently selected
pages appears.
2
Press the MENU ON/OFF/PAGE switch toward the PAGE position
(or use the rotary encoder) until the OPERATION MODE 2/2 page
appears, as shown below.
3
Push the MENU CANCEL/PRST/ITEM switch toward the ITEM
position.
Next press the rotary encoder, to display a question mark to the left
of "TIME CODE DISP".
4
Turn the rotary encoder to select whether or not to display or output
the time code and other information.
To display or output the information: turn the rotary encoder
counterclockwise as seen from the front of the camera to select
one of the following settings.
• VF: display in the viewfinder.
• TEST: output from the TEST OUT connector.
• BOTH: display in the viewfinder and output from the TEST
OUT connector.
OPERATION MODE 2/2
TIME CODE DISP
Chapter 4 Adjustments and Settings for Recording
: OFF
4
(Continued)
4-71