Sony DNW-7/7P Operation Manual page 137

Setting change and adjustment progress messages and display modes
Message display
condition
When the filter selection
has been changed
When the gain setting
has been changed
When the setting of the
WHITE BAL switch has
been changed
When the OUTPUT/
DCC selector has been
set to DCC ON or OFF
When the shutter speed
and mode setting has
been changed b)
When the black or white
balance has been
adjusted
a) When the TURBO GAIN button is pressed, "TURBO" is displayed
regardless of the GAIN setting.
b) This is also displayed for about 3 seconds when the SHUTTER selector
is set to ON.
c) DNW-90/90P/90WS/90WSP only
Message
FILTER : n (where n = 1, 2, 3,
4)
GAIN : n (where n = 3dB,
0dB, 3dB, 6dB, 9dB, 12dB,
18dB, 24dB, 30dB, 36dB,
42dB,TURBO a) )
WHITE : n (where n = A CH,
B CH, PRST) or ATW : RUN
DCC : ON (or OFF)
: SS : 1/100 (DNW-7/90/
90WS/9WS) or 1/60 (DNW-
7P/90P/90WSP/9WSP) (or
1/125, 1/250, 1/500, 1/1000,
1/2000, CLS, ECS
E.g. WHITE : OK
For more informarion, see
Section 4-1 "Adjusting the
Black Balance and the White
Balance" (page 4-1).
Chapter 4 Adjustments and Settings for Recording
Y: Message is displayed.
N: Message is not displayed.
Display mode
setting
1
N
N
N
N
N
c)
, EVS)
N
2 3
N Y
4
N Y
N Y
Y Y
Y Y
Y Y
4-59